Description
Basic Weight Control Valve Flange Segment Ball Valve consists of an integrated intelligent electric actuator and v-notch ball valve.
It is mainly used in the accurate control of pulp flow in the paper-making machines to meet people’s increasing demand for paper quantity and quality.
Feature
High resolution, accurate flow control,high repeatability, no backlash;
Precise feedback,accurate control of paper quality,withightweight design and easy installation;
Digital setting and display on electronic control panel (0- 100.0%)
Suitable for connection with DCS/QCS and other control systems
V-Notch Ball Valve
Valve Body
- Integral design
Ball Design
- V-notch Ball
Seat Options
- metal seat (-40~300 ℃
- soft seat (-40~180 ℃）
End Connection
- Flange
Rangeability
- 300∶1
Flow Characteristics
- EQ%
Valve Size Range
- DN25~600mm
- NPS1″-24”
Pressure Range
- DIN PN 16 PN25 PN40 PN63
- ANSI 150,ANSI 300
Pressure Range
- ANSI/FCI 70.2 IV/100(Metal Seat)
- ANSI/FCI 70.2 VI(Soft Seat)
Intelligent Electric Actuator
Output torque options
- 1：140
- 1：160
Stepper motor
- 2phase pulse
Full step length options：
- 7000
- 8000
Half step length options：
- 14000
- 16000
1/4step length options：
- 28000
- 32000
Rotation options：
- 35
- 40
Limit switch number
- 2 pieces
- 24vdc
- normally open
Feedback potentiometer：
- 1KΩ±0.1%
- 4mA- Full closing valve position
- 20mA- Full open valve position
Image Show of Basic Weight Control Valve Flange Segment Ball Valve
Structure
The valve is controlled by an electric actuator driven by a stepper motor, which is connected to the valve through a gear mechanism with high deceleration ratio (no Backlash). The full travel time of the valve can be determined by the step angle of the stepper motor or the deceleration ratio of the reducer.
The time can be set from 30 seconds to 600 seconds. The total travel time of the general valve operation is set to 240 seconds (4 minutes).
Its rear cover has an electronic control panel on which the LED number XX.X% shows the opening of the valve. The valve opening signal comes from the precise position sensor at the valve. This signal is converted into 4-20mA current signal from the special circuit board in the actuator and sent to the electronic control device. The effect of this signal transformation can minimize interference.
1. Segment Ball valve
2.Bracket
3.Valve position indication
4.Coupling
5.Output shaft
6.Valve Position Inspection Mechanism
7.Flexible reducer
8.Stepper motor
9. Waterproof cable head PG9
10.Manual rear axle（Manual rotary valve）
11.Connection terminal
12. led Digital display
13.Function button